迷你符合性设备，适用于小抓持器
• X-Y 及 α 角符合性[1]。
• 在方向 Z 为刚性。
• 一根空气导管连接至中央零位 [2]。
• 另一根空气导管可锁定任何偏移位置 [3]。
Mini compliance device, for small grippers
• X-Y and angle α compliance [1].
• Rigid in Z direction.
• One air lead to get the central zero psition [2].
• Another air lead to lock in any offset psition [3].
编程单个SB8F
在对传感器盒进行编程之前，请确保有线输入处于所需配置（开/关）以启用输出。按下AUTOSET按钮并按住3秒钟，直到READING红灯开始闪烁，然后松开。红灯（READING）闪烁表示微处理器正在读取和存储全部输入的状态。然后红灯熄灭，启用了输出。黄灯（STORED）指示启用输出。
Before programming the sensor box, make sure that the wired inputs are in the confguration (ON/OFF) desired to enable the output. Press the AUTOSET button and hold it down for3 seconds until the READING red light starts fashing, then release it.Thered light (READING) fashing indicates that the microprocessor is reading and storing the state of all the inputs. Then the red light goes off and the output is enabled. Output enabling is indicated by the yellow light (STORED).
双钳口自动校准平行i气动钳夹(SZ系列)
•双作用。
•弹簧关闭；如需要时弹簧打开 。
•多种的紧固和输送选项。
•可选的磁传感器。
•FDA-H1 食品级润滑脂。
•不锈钢颚式钳。
•Double acting.
•Available with normally closed or normally open spring on
request.
•Various options for fastening and feeding.
•Optional magnetic sensors.
•FDA-H1 food-grade grease.
•Stainless steel jaws.
