价格:未填
起订:1
发货:3天内

发送询价

6分钟前 mono了解更多「螺耐斯」[螺耐斯10e361c]内容：Ｄ、限位器D, limiting device限位器为一个底部带限位板和流通通道的短节，接在定子的尾部，其作用是施工作业时给转子限位以防止下入过头而失去作用和杆柱脱落时防止杆柱掉入井底。The limiting device is a short section with bottom limit plate and distribution channel, which is connected to the tail of the stator. Its function is to limit the rotor to the rotor during ctruction1, so as to pvent it from falling into the overhead and lose its function and pvent the rod from falling into the bottom when the rod string falls off.

Ｅ、抽油杆扶正器E, sucker rod centralizer抽油杆扶正器由心轴和扶正筒组成，它接在两根抽油杆之间，被卡在两个抽油杆接箍之间。心轴也就是一要极短的抽油杆短节。扶正筒是一个内孔比心轴大１ＭＭ左右的空心塑料筒，外部有四个略比油管内径小的扶正翼，采取浇注成型。扶正筒可以围绕心轴转动，防止抽油杆旋转时与内壁接触而磨蚀油管，又可以让流体通过。The sucker rod centralizer is comed of the heart shaft and the upright cylinder, which is connected between the two sucker rods and is stuck between the two sucker rod hoops. The axis of the heart is also an extremely short rod short section. The centering cylinder is a hollow plastic tube inner hole Bixin shaft around 1MM, external four slightly smaller than the diameter of the tubing centralizer wing, adopt casting. The centralizer can revolve around the axis to pvent the sucker rod from touching the inner wall when it rotates, and it can also let the fluid pass through.

211G型单螺杆泵可无脉动地工作 　　G型单螺杆泵工作时,通过螺杆转子与泵套的孔壁间形成的一个个密封腔,平稳地从低压区运送到高压区,在整个运送过程中,介质作纯轴向运动,可完全做到无脉动地运送介质。这一点与齿轮泵不同。齿轮泵工作时,在齿轮的转动下,介质作轴向与径向及其复合方向的运动,产生明显的搅拌现象。其输出压力的表现形式:G型单螺杆泵的输出压力比较稳定,齿轮泵则出口压力会有波动。这一点在输送高粘度的介质(如重油等)时比较突出。